Power supply, Switching the receiver off

11 Power supply

Your EK 3041-U receiver can be powered from different power sources. The adaption to these power sources is via the plug-in connector at the bottom of the receiver and the corresponding accessories.

The EK 3041-U can be powered

•directly via the camcorder with 12 V or 5.6 V or

•via the GA 3041-B power adaptor which is attached to the special housing

12 Putting the receiver into operation / Switching the receiver on

If the receiver is inserted in the slot-in facility of a camcorder, the receiver is switched on as soon as the camcorder is put into operation. The receiver’s ON/OFF switch is then locked. If the ON/OFF switch is pressed, „Loc“ appears on the display.

If the receiver is mounted into a special housing for external attachment to camcorders, press the ON/OFF switch to switch the receiver on. After approx. two seconds, the display indicates the receiving frequency or its respective channel number.

Two bargraphes indicate the received RF signal (upper bargraph: „RF“) and the deviation (lower bargraph).

13 Switching the receiver off

To switch the receiver off, press the ON/OFF switch for approx. one second until „OFF“ briefly appears on the display.

Please wait at least two seconds before switching the receiver on again.