Windows 3.1 and DOS
The PCMCIA Card Drive CD-10 connects to Adaptec’s SCSI board. It also uses Adaptec’s software driver EZ-SCSI. This section assumes that Adaptec’s SCSI board and EZ- SCSI software are installed. For installation of the SCSI board and EZ-SCSI, consult the manuals for those items.
When connecting the CD-10 drive to the computer with EZ-SCSI installed, the EZ-SCSI software should be rein- stalled after connection.
Applicable environment
The CD-10 drive can be used in the following environment:
- SCSI board : | AHA-1542CF |
- Software driver: | EZ-SCSI V.3.04 |
- Operating system: MS-DOS 6.20
Checking the EZ-SCSI driver
(1)Check the directory in which the EZ-SCSI software is installed. In general, EZ-SCSI is installed in the “SCSI” directory. In this directory, the following two files must be stored: ASPIxDOS.SYS and ASPIDISK.SYS
CAUTION: EZ-SCSI may be installed in directories with names other than ÒSCSIÓ. In the directory where EZ-SCSI is installed, there are usually various utility files as well as ASPIxDOS.SYS and
ASPIDISK.SYS.
(2)When EZ-SCSI is properly installed, the CONFIG.SYS file must contain the following two lines:
DEVICE=C: SCSI ASPIxDOS.SYS /D
DEVICE=C: SCSI ASPIDISK.SYS /D
*ASPIxDOS.SYS, the ASPI DOS manager, depends on the SCSI board. See following Note.