Server Settings
The Server Settings page contains the configurable settings for the SentryII server. If your server requires values other than the defaults, enter the correct values and select Save. A message will be displayed confirming that the changes have been saved.
The following is a description of the fields contained on this page:
• | API Port | SentryII’s API communications port. The default port 8888 may be changed if it |
|
| conflicts with another service running on the computer. (NOTE: This port is used to |
|
| communicate with all SentryII Remote clients.) |
• | Web Server Port | SentryII uses this port to communicate with a web browser. The default port 80 may be |
|
| changed if it conflicts with another web server running on the computer. |
• | Serial Communications Port | SentryII uses this port to communicate with the UPS. Select the port the UPS has been |
|
| connected to. |
• | Baud Rate | SentryII communicates with the UPS using this baud rate. This rate will be auto detected |
|
| from the UPS when the SentryII service is started. If not, please refer to the |
|
| documentation provided with your UPS. |
• | SMTP Server | The SMTP server name or IP address supplied here will be used to send email |
|
| notifications. |
• | Contact Closure UPS | Select this checkbox if the UPS supports contact closure and you would like SentryII to |
|
| use this mode. (NOTE: Units connecting to an AS400 computer will benefit most from |
|
| this feature. Contact Closure requires a |
|
| 35000015) |
NOTE: If the UPS is connected to any com port other than com 1 the default page will not display until the required com port is selected and your web browser is restarted.
- 14 -