Followed by a 3 second pause.
The numbers 8007597243 would be dialed.
Followed by a 15 second pause.
The numbers 123456 and # would be dialed.
Followed by a 9 second pause.
Then, the numeric add or remove alarm would be sent as the pager message.
End of example.
Logging
You can configure SentryII to log the event to the event log file. For instructions on how to view the event log, see the View Event Log section.
To set up logging for an event, select the Logging button. The following configuration page will be displayed.
Select the Logging Enabled checkbox to enable logging for the event, and select the OK button. A message will be displayed confirming that the settings have been saved.
SNMP Trap
You can configure SentryII to send a SNMP trap, to up to 10 other computers on the network, when an event occurs. To set up a SNMP trap for an event, select the Trap button. The following configuration page will be displayed. Enter the desired configuration and select the OK button. A message will be displayed confirming the settings have been saved.
The following is a description of the fields contained on this page:
• Event | Displays the name of the event that is being configured. |
- 18 -