Minuteman UPS SentryII UPS user manual

The following is a description of the fields contained on this page:

•	Event	Displays the name of the event that is being configured.
•	Paging Enabled	Select the checkbox to enable paging for this event. This option allows you to retain
		your settings whether the option is enabled or disabled.
•	Delay	The amount of time in seconds, after the event occurs, before paging is performed.
		If the event is removed before the delay time is reached, the paging will be cancelled.
•	Port	The dedicated serial communications port used when paging is performed. A
		modem must also be available and properly configured for this port.
•	Alarm-Add	The numeric message sent, as the page, when an event is added.
•	Alarm-Remove	The numeric message sent, as the page, when an event is removed.
•	Pager Number	Up to five separate pages may be configured. Each field must contain only one
		paging phone number followed by any codes required by the paging service to
		complete the page.
		The phone number must contain any access numbers required for the phone system
		to gain access to an outside line, such as dialing 8 or 9. Each comma (,) represents
		three (3) seconds dialing pause time. This allows the modem to pause before
		sending a sequence of numbers to the paging system. There may be times, when a
		pause is required, before the paging system is ready to receive the next numeric
		command.
		It may be necessary to test the pause time until it is determined to be functioning
		properly. This may require an event to be manually triggered. See the UPS Control
		Options section to trigger an event.
		Valid characters are limited to 0 through 9, comma (,) and the pound sign (#).
		An example pager number follows: 1,8007597243,,,,,123456#,,,
		The numeric 1 would be dialed.
		- 17 -