Powercom 1500A, 800A, 2000AL, ls600A Troubleshooting, Storage conditions, Extended storage

8)Place your new battery in the same position/direction and reconnect the wires red wire-position(+) and black wire negative(-)

9)Please follow steps 5,4 and 3 (in that order) to reconnect the entire unit.

10)Please follow manual instructions in order to properly reconnect your equipment.

11. Storage

10.1 Storage conditions

Store the UPS covered and upright in a cool , dry location, with its battery fully charged. Before storing, charger the UPS for at least 4 hours. Remove any accessories in the accessory slot and disconnect any cables connected to the computer interface port to avoid unnecessary draining the battery.

10.2 Extended storage

During extended storage in environments where the ambient temperature is -15 to +30 (+5 to +86 ), charge the UPS‘ s battery every 6 months.

During extended storage in environments where the ambient temperature is +30

to +45 (+86 to +113 ), charge the UPS‘ s battery every 3 months.

12. Troubleshooting

PROBLEM	POSSIBLE	ACTION TO TAKE
	On/test button not	Press the on/test button to power the UPS
	pushed or push too	and the load
	short
	UPS input circuit	Reduce the load on the UPS by unplugging
UPS will not turn on	break tripped	equipment and reset the circuit breaker by
		pressing the plunger back in
	Very low or no utility	Check the AC power supply to the UPS with
	voltage	multimeter
	Computer interface	Disconnect the computer interface or
UPS will not turn on or	of accessory	accessory. If the UPS now works normally,
off	problem	check the interface cable, the attached
	Push on/test or off	computer and the accessory
	button too short
UPS operates on-	UPS’ s input circuit	Reduce the load on the UPS by unplugging
battery even though	breaker tripped	equipment and reset the circuit breaker
normal line voltage is
UPS beeps occasionally	Normal UPS operation	Normal condition
UPS does not provide	The UPS’ s battery is	Charge the battery