POSIFLEX Business Machines PP5600 SERIES user manual Connecting Cables, Serial connection

II.QUICK START-UP

A. CONNECTING CABLES

1.Serial connection

All the external connectors are in the recessed area at the rear bottom. The serial connector is a 9 pin D sub Female connector at the right in the picture above. Apply the male connector of RS232 cable to this port for serial application. Please note that when serial connection is used, there must be no cable connection at the parallel port on the printer. The default protocol used in serial connection is 9600 bps, none parity check, 8 data bits, 1 stop bit.

2.Parallel connection

The parallel connector is a 25 pin D sub Male connector at the leftmost location in the connector area. Apply the female end of the parallel cable at this port for parallel application. Please note that when parallel connection is used, there must be no cable connection at the serial port on the printer.

3.Peripheral connection

The peripheral controller is a RJ11 jack near the serial connector. With use of Posiflex cash drawer cable 20863018001 (CCBLA-180-1), this port can control a Posiflex cash drawer CR3100 or CR3200 or CR4000 or CR4100. If a Posiflex special split cable 20867023800 (CCBLA-238) is used instead, this port can control two cash drawers of above models.

2 - 1