turning the ribbon feed knob of the ribbon cartridge counterclockwise. The ribbon must be properly tightened to be able to set in position in installation. Never turn the knob the other way round or the ribbon may mess up inside the cassette and ruin the whole cassette.
∙If in process of replacing the ribbon cassette, the cassette shall be removed in the manner that the side of the knob is pulled up first with the end of the holding tab remain held down.
∙Place the ribbon cartridge in position as shown in the picture. Seat the side with the holding tab first then press down the whole cassette. Rotate the ribbon feed knob counterclockwise during the action pressing down the ribbon cartridge into position to help the installation operation if necessary.
∙Turn the knob counterclockwise to remove slack in
ribbon for use.
∙ Apply even force |
|
to close the auto |
|
cutter (PP5600B) | Î |
so that the small | |
lug of auto cutter |
|
can seat in right |
|
position on the |
|
Fastening Knob
2 - 3