When the printer is used as a kitchen printer, please use this port for kitchen bell connection instead.
4.Power connection
The power connector is a 3 pin jack between the peripheral connector and the parallel connector. Either a Posiflex supplied power adaptor or a printer power cable from a Posiflex POS system can be connected to this connector to supply power for this printer. During insertion of the power plug, be sure to hear the click to obtain a firm contact.
CAUTION: Before doing the insertion or extraction of the power plug, be sure to pull the outer sleeve of the plug backward to release the internal latch. Failure to do this could damage the power plug. Such damage is considered as an artificial destruction and is not covered by the warranty.
When all the above cable connections are made correctly, you may connect your power adaptor to the wall outlet. Make sure that the type of power cord and the voltage requirement of the power adaptor meet the local power conditions. Do not turn the power on for the moment.
B. LOADING / REPLACING RIBBON CASSETTE
∙Turn off the power to the printer.
∙Lift the front end of the top cover to remove it.
∙Open the auto cutter by pulling the tab up if it is installed in the printer. (PP5600B)
∙Remove slack in the ribbon by
Lift Tab
2 - 2