bracket of the print mechanism as in the picture.
∙Close the top cover by fitting its rear end lug first for ribbon replacement only or go on loadin g paper as in next paragraph.
C. LOADING PAPER
1.Drop the paper roll inside the paper compartment in the orientation as shown in left picture below.
2.Cut the leading edge of paper roll perpendicular to paper direction and now please turn on the
power to the printer by pressing the power button in front side of the printer. Insert the leading end of the paper roll into the paper intake slot on print mechanism. Insert the paper till you feel the front end caught by the
paper feed roller inside the print mechanism then the paper will automatically advance to proper position (paper exit of print mechanism). In case there was a slip at the insertion of the leading end of paper roll and you want to keep same heading clearance, you may press the FEED button to advance the paper to position.
3.Close the top cover back. Should the front end of paper roll tend to curl as when it comes near end of the paper roll, it is advisable to press the FEED button to check if the paper comes out of the slot in top cover. Engage manual support to make sure it comes out if it fails.
2 - 4