III. MAINTENANCE GUIDES
A.MAINTENANCE GUIDE LINES
Always turn off and disconnect power before start.
Please pay attention not to be hurt by any sharp edge of the metal parts when handling the interior of the printer.
Do not touch the print head and motor after printing. It can become very hot.
Never use benzene, benzine, thinner, trichloroethylene alcohol, or ketone based solvents on the printer’s plastic and rubber components.
B. GENERAL CLEANING
Please use a soft hair brush or compressed air to clear away any dust or paper scraps accumulation inside the printer. Check also the area of the
C. TROUBLE SHOOTING
This section gives solutions to some printer problems you may have.
1.General Problems
No LED lights up on control panel when switched on – Make sure that the power supply cables are correctly plugged into the printer, the power adaptor and to the power outlet. Make sure that power is supplied to the power outlet. If the power outlet is controlled by a switch or timer, try use another outlet.
3 - 1