Magnavox G43TWINS-FULLHD user manual Onboard Headers and Connectors, IDE1

Page 26

2.9 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.12 No. 22)

Pin1 FLOPPY1

the red-striped side to Pin1

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.12 No. 7)

 

PIN1

IDE1

 

 

connect the blue end

 

connect the black end

to the motherboard

 

to the IDE devices

80-conductor ATA 66/100/133 cable

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

(SATAII_1:

see p.12, No. 12) (SATAII_2: see p.12, No. 11)

SATAII 2

SATAII 1

These six Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s

(SATAII_3:

see p.12, No. 13) (SATAII_4: see p.12, No. 14) (SATAII_5: see p.12, No. 16) (SATAII_6: see p.12, No. 15)

SATAII_5 SATAII_3

SATAII_6 SATAII_4

data transfer rate.

Serial ATA (SATA)

Either end of the SATA data cable

Data Cable

can be connected to the SATA /

(Optional)

SATAII hard disk or the SATAII

 

connector on this motherboard.

2 6

Image 26
Contents G43Twins-FullHD Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Unique Feature ConnectorBios Feature Rear Panel I/OCertifications FCC, CE, WhqlPage CPU DVD Motherboard Layout ATXPWR1ASRock GLAN8CH I/O Table for Audio Output ConnectionASRock DVIDisplayPort Card Specifications Pre-installation Precautions Screw HolesCPU Installation Page Installation of CPU Fan and Heatsink Installation of Memory Modules Dimm DDR3A1 DDR3B1Installing a Dimm Pcie slots Installing an expansion cardExpansion Slots PCI and PCI Express Slots DisplayPort DVI-D port Installation of ASRock DVIDisplayPort CardPCIE2 slot What is HDCP? Hdcp FunctionJumpers Setup PS2USBPWR1FSB1066 / DDR2 Onboard Headers and Connectors IDE1USB 2.0 Headers Internal Audio Connectors Chassis Fan Connector Sataii Hard Disk Setup Guide Western DigitalWhat is Hot Plug Function? Hot Plug Function for Sata / Sataii HDDsSata / Sataii HDD Hot Plug Feature and Operation Guide Points of attention, before you process the Hot PlugHow to Hot Plug a Sata / Sataii HDD How to Hot Unplug a Sata / Sataii HDDMake a Sata / Sataii Driver Diskette Driver Installation GuideUsing Sata / Sataii HDDs with NCQ function Set Up Bios Install Windows VistaTM / VistaTM 64-bit OS on your system Using Sata / Sataii HDDs without NCQ function Set up BiosInstall Windows 2000 / XP / XP 64-bit OS on your system Untied Overclocking Technology Bios Menu Bar Navigation Keys Main ScreenSmart Screen CPU Configuration CPU ConfigurationOverclock Mode Overclock Mode AutoPcie Frequency MHz Boot Failure GuardCPU Frequency MHz Spread SpectrumChipset Configuration Dram tRP Dram tCLDram tRAS Dram tRCDPavp Mode Dram CH0 tRD Phase AdjustDram CH1 tRD Phase Adjust Dvmt Mode SelectCD-In OnBoard HD AudioFront Panel OnBoard LanAcpi Configuration Sataii Configuration Enhanced IDE ConfigurationSataii Configuration Acpi Hpet TablePIO Mode IDE Device ConfigurationLBA/Large Mode Block Multi-Sector TransferPCIPnP Configuration OnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressUSB Controller USB ConfigurationUSB Controller Enabled USB 2.0 SupportCPU Quiet Fan Target CPU TemperatureHardware Health Event Monitoring Screen Target Fan SpeedFull Screen Logo Boot ScreenBoot Settings Configuration AddOn ROM DisplayBoot Up Num-Lock Boot LogoBoot From Onboard LAN Security ScreenDiscard Changes and Exit Would you like to save current setting user defaults?Exit Screen Discard ChangesRunning The Support CD Install Operating SystemSupport CD Information Drivers Menu