Opticon LGZ 7225 user manual EAN-13, Disable Enable Read

Page 33

EAN-13

Read: Format

Data Digits (12 Digits)

Check Digits

Check-sum verification: The checksum of EAN-13 is optional and made as the sum of the numerical value of the data digits.

Check-sum transmission: By setting Enable, checks sum will be transmitted.

Max./Min. code length: Each symbology has own Max./Min. Code Length. They can be set to qualify data entry. If their Max./Min. Code Length is zero, the Global Min./Max. Code Length is in effect. The length is defined as to the actual barcode data length to be sent. Label with length exceeds these limits will be rejected. Make sure that the Minimum length setting is no greater than the Maximum length setting, or otherwise all the labels of the symboblogy will not be readable. In particular, you can see the same value for both Minimum and Maximum reading length to force the fixed length barcode decoded.

Truncate leading/ending: Refer to Truncate leading/ending of UPCA.

				Program
				Program

	Option Bar Code			Option	Alphanumeric
					Entry

			Disable		00
			Disable		00
			Enable		01
			Enable		01
Read

33

Image 33

Contents User’s Manual Contents Getting Started LGZ7225 Long Range Handheld CCD Spec Default Setting for each barcode shown as below Programming To program each option, you must Programming LGZ7225Exit Exit Interface SelectionKeyboard wedge Keyboard wedge USA Keyboard wedge 00-99 10 msec Block transmission Delay Flow control RS-232RTS/CTS Option Bar Code Alphanumeric Entry Bar/space polarity Wand EmulationWand Emulation Exit Scan Scanning modeTime 00-99 00-09 No double Double confirm Confirm Scan Exit Beep loudness/Beep tone freq./Beep tone duration You IndicationOption Bar Code Alphanumeric Entry Read Format UpcaExit UCC/EAN Upce Supplement digits Insertion group selection Refer to Insertion groupAuto detection Disable Enable EAN-13 Disable Enable ReadExit Format Data Digits Check Supplement Digits Or 5 or ISBN/ISSN EAN-8 Exit Supplement digits Format Code Code Id setting Refer to Code ID setting of Upca Exit Disable Enable Append Start/end Transmission Interleaved 2 Insertion group selection Refer to Insertion group Exit Industrial 2 Exit Program Option Bar Code Alphanumeric Entry Matrix 2 of 5 EurExit Codabar Exit ABCD/ABCD Code-128 00-64 Max. code length Min. code length UCC/EAN-128 Code-93 Exit Code-11 Exit MSI/plessey Exit UK/plessey Exit Telepen 1XPHULFRQO\ Standard 2 Exit China Post Exit Italian Pharmacode Exit String setting None Characters FfH Ascii String setting Exit Transmission Exit AIM ID Format of barcode data transmission 7HVW&KDUW Page Ascii Code RWH Program Barcode standard parameter setting list Parameter Setting ListSystem parameter setting list String setting listFirmware version list Finish