Opticon LGZ 7225 user manual Programming LGZ7225, To program each option, you must

Page 7

Programming the

LGZ7225

To program the LGZ7225 you must scan a series of programming barcode in the correct order. Fold out the back cover of this manual. You will see a table of alphanumeric barcodes, which are used to program the various options presented.

To program each option, you must:

1.Scan the Program barcode on the parameter setting part.

2.Enter the option mode by scanning the Option Bar Code (also on the Parameter setting part).

3.To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these alphanumeric entries from the back fold out page. To confirm above steps, you must scan the Finish barcode on the back fold out page.

4.Once you have finished programming. Scan the Exit barcode, listed on the lower right hand corner of each parameter setting part.

7

Image 7

Contents User’s Manual Contents Getting Started LGZ7225 Long Range Handheld CCD Spec Default Setting for each barcode shown as below Programming To program each option, you must Programming LGZ7225Exit Exit Interface SelectionKeyboard wedge Keyboard wedge USA Keyboard wedge 00-99 10 msec Block transmission Delay Flow control RS-232RTS/CTS Option Bar Code Alphanumeric Entry Bar/space polarity Wand EmulationWand Emulation Exit Scan Scanning modeTime 00-99 00-09 No double Double confirm Confirm Scan Exit Beep loudness/Beep tone freq./Beep tone duration You IndicationOption Bar Code Alphanumeric Entry Read Format UpcaExit UCC/EAN Upce Supplement digits Insertion group selection Refer to Insertion groupAuto detection Disable Enable EAN-13 Disable Enable ReadExit Format Data Digits Check Supplement Digits Or 5 or ISBN/ISSN EAN-8 Exit Supplement digits Format Code Code Id setting Refer to Code ID setting of Upca Exit Disable Enable Append Start/end Transmission Interleaved 2 Insertion group selection Refer to Insertion group Exit Industrial 2 Exit Program Option Bar Code Alphanumeric Entry Matrix 2 of 5 EurExit Codabar Exit ABCD/ABCD Code-128 00-64 Max. code length Min. code length UCC/EAN-128 Code-93 Exit Code-11 Exit MSI/plessey Exit UK/plessey Exit Telepen 1XPHULFRQO\ Standard 2 Exit China Post Exit Italian Pharmacode Exit String setting None Characters FfH Ascii String setting Exit Transmission Exit AIM ID Format of barcode data transmission 7HVW&KDUW Page Ascii Code RWH String setting list Parameter Setting ListProgram Barcode standard parameter setting list System parameter setting listFirmware version list Finish