Opticon LGZ 7225 user manual String setting

Page 75

String setting

Insert G1/G2/G3/G4 character setting: The scanner offer 4 positions and 4 characters to insert among the symbol. Example: Barcode “1 2 3 4 5 6”.

Output- Barcode “1 2 A B 3 4 C D 5 6”.

Steps:

1)Scan Programming and Insert G1 characters setting barcode.

2)Use the ASCII code table to find the value of Aඎ41,Bඎ 42.

3)Scan 4, 1 and 4, 2 from the barcode on the fold out back page.

4)Scan Finish from the barcode on the fold out page.

5)Repeat the same procedure in Insert G2 characters setting.

6)Scan Exit barcode.

7)Insert data group 1-4 position. Please refer to Chapter- Transmission, page 65 and in specific barcode that you want to use.

Program

 

Option Bar Code

Option

Alphanumeric

 

 

 

 

Entry

 

 

 

 

 

 

 

 

None

00

 

 

 

 

 

 

1-22 characters

00-ffH ASCII

 

 

 

Insert G1 characters

 

code

setting

 

 

 

 

 

 

 

 

 

 

None

00

 

 

 

 

 

 

1-22 characters

00-ffH ASCII

 

 

 

Insert G2 characters

 

code

setting

 

 

 

 

 

 

 

75

Page 74 Page 76
Image 75
Page 74 Page 76
Contents User’s Manual Contents Getting Started LGZ7225 Long Range Handheld CCD Spec Default Setting for each barcode shown as below Programming To program each option, you must Programming LGZ7225Exit Exit Interface SelectionKeyboard wedge Keyboard wedge USA Keyboard wedge 00-99 10 msec Block transmission Delay Flow control RS-232RTS/CTS Option Bar Code Alphanumeric Entry Bar/space polarity Wand EmulationWand Emulation Exit Scan Scanning modeTime 00-99 00-09 No double Double confirm Confirm Scan Exit Beep loudness/Beep tone freq./Beep tone duration You IndicationOption Bar Code Alphanumeric Entry Read Format UpcaExit UCC/EAN Upce Supplement digits Insertion group selection Refer to Insertion groupAuto detection Disable Enable EAN-13 Disable Enable ReadExit Format Data Digits Check Supplement Digits Or 5 or ISBN/ISSN EAN-8 Exit Supplement digits Format Code Code Id setting Refer to Code ID setting of Upca Exit Disable Enable Append Start/end Transmission Interleaved 2 Insertion group selection Refer to Insertion group Exit Industrial 2 Exit Program Option Bar Code Alphanumeric Entry Matrix 2 of 5 EurExit Codabar Exit ABCD/ABCD Code-128 00-64 Max. code length Min. code length UCC/EAN-128 Code-93 Exit Code-11 Exit MSI/plessey Exit UK/plessey Exit Telepen 1XPHULFRQO\ Standard 2 Exit China Post Exit Italian Pharmacode Exit String setting None Characters FfH Ascii String setting Exit Transmission Exit AIM ID Format of barcode data transmission 7HVW&KDUW  Page Ascii Code RWH  String setting list Parameter Setting ListProgram Barcode standard parameter setting list System parameter setting listFirmware version list Finish
Top Page Image Contents