Lanner electronic FW-7890 user manual Suspend Type, Suspend Mode, HDD Power Down, Resume by Alarm

V/H	This selection will cause the system to turn off the vertical and
SYNC+Blank	horizontal synchronization ports and write blanks to the video buffer.
Blank Screen	This option only writes blanks to the video buffer.
DPMS	Initial display power management signaling.

Suspend Type

Select the Suspend Type.Configuration options: PWRON Suspend / Stop Grant

Suspend Mode

When enabled and after the set time of system inactivity, all devices except the CPU will be shut off. Configuration options: Disabled / 1 Min / 2 Min / 4 Min / 8 Min / 12 Min / 20 Min / 30 Min / 40 Min / 1 Hour .

HDD Power Down

When enabled and after the set time of system inactivity, the hard disk drive will be powered down while all other devices remain active.

Configuration options: Disabled / 1 Min / 2 Min / 3 Min / 4 Min / 5 Min / 6 Min / 7 Min / 8 Min / 9 Min / 10 Min / 11 Min / 12 Min / 13 Min / 14 Min / 15 Min

Soft-Off by PWR-BTTN :When set to delay 4 sec, the function allows the power button to put the system in Suspend, a power saving mode. When set to Instant-off the Soft-Off by PWR-BTTN function is disable and the computer turns completelyoff when the power button is pressed.

Wake-Up by PCI card: Enable this selection to use the Wake up by PCI card.

Resume by Alarm

You can set "Resume by Alarm" item to enabled and key in Data/ time to power on system.

Disabled	Disable this function.
	Enable alarm function to POWER ON system.
Enabled	If RTC Alarm Lead To Power On is Enabled.
	Date (of Month ) Alarm : Every day , 1~31
	Time (hh: mm: ss) Alarm : (0~23) : (0~59) : (0~59)

FDD,COM,LPT Port

Configuration options: Enabled / Disabled

PWRON After PWR-Fail :Select Enabled, this setting will let the power switch always under on-line status after commercial power back to normal.