Pentax 15921 manual Press the four-way controller 2 in a mode

Focusing may be compromised if you move the camera while the self- timer lamp is blinking when taking still pictures.

• For movies, recording will start ten seconds or two seconds after the C button is pressed.

•Press the shutter release button halfway while the self-timer is running to stop the countdown and press fully to restart the countdown.

•Z cannot be selected while the 9 (Green) mode settings remain at default. However, it can be selected if you select Zin another shooting mode first, and then switch the shooting mode to 9.

Taking a Series of Pictures

(Continuous Shooting/Burst Shooting Mode)

In these modes, pictures are taken continuously as long as the shutter release button is pressed.

		Each time an image is taken, it is saved in the memory before the
	Continuous	next image is taken. The higher the image quality, the longer the
j	Shooting	interval between shots.
		You can continue shooting until the capacity of the SD Memory
		Card or the built-in memory is full.
q	Burst	The number of recorded pixels is fixed at f (2592×1944) and
	Shooting	pictures are taken consecutively.

The number of pictures that can be taken consecutively and the frame rate per second vary depending on the shooting condition.

1 Press the four-way controller (2) in A mode.

The [Drive Mode] screen appears.

3 TakingPictures

2 Use the four-way controller (45) to select j or qand press the

4button.

The camera is ready to take a series of pictures.

Drive Mode

Continuous Shooting

MENU Cancel OK OK

85