Waves Q-Clone manual Nuendo/Cubase SX

C.Reset – Reset the preset by loading the “reset preset” file from the Load menu.

D.Add on top – By clicking the “Add” button you can load a new preset on top of an existing one. The “Add” mode gives the effect of having 2 or more EQ devices in a chain. There are 2 options for Add mode:

i.Open a Q-clone preset (from the Q-Clone preset menu or any directory on your hard drive) or use the existing displayed EQ curve. Click the “Add” button, and then make changes to it. Note that changes should be done from a flat EQ starting point.

ii.Load an EQ on top of the existing Q-Clone EQ curve on your screen. This preset can be loaded from the Q-Clone preset menu or from any directory on your hard drive.

Nuendo/Cubase SX 2.x-3:

1.Connect a cable from one of your audio card output ports into the input of the EQ device.

2.Connect a cable from the output of the EQ device to your audio card input port.

3.Set all of the frequencies gain knobs on your EQ device to 0 db and turn any filters off.

4.Open your Nuendo/Cubase SX recording session.

5.Open a new mono audio track. It will be dedicated to the Q-Capturecomponent.

6.Open “devices” from the Cubase menu bar and open “Device Setup”. Choose the “VST Audiobay” and uncheck the “Direct Monitoring” checkbox.

Waves Q-Clone Manual 15