Waves Q-Clone manual

Page 6

The Receiving section also shows an input meter to indicate the signal level returning from your EQ device, back into the channel.

CALIBRATION SECTION – The Headroom slider and the In and Out meters are on the right side of the Q-Capture. These not only indicate that signal is being received, but can also help to adjust the Headroom fader of the Transmitting section. This is to insure optimal dynamic range and to avoid clipping in the analog device. Please see the Calibrating section on page 11 for more information.

If you find that you are not getting a signal, there can be multiple reasons for this. All reasons are fairly straightforward and are related to routing and live input monitoring. Please follow the set-up step by step directions on page 13, then consult our Troubleshooting section or EQ sampling loop checklist and diagram if you encounter problems.

Waves Q-Clone Manual

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Waves Q-Clone EQ Sampling System Introduction Behind the Scenes Plug-in components Capture Component Page Clone Component Frequency Response Graph Trim Using the Q-CLONE System Calibrating Page Quick Start up and Set up Pro-tools 6.7 LE and TDMWaves Q-Clone Manual Nuendo/Cubase SX Page Waves Q-Clone Manual Page Page Save your EQ to a new preset file anywhere on your computer Sonar Waves Q-Clone Manual Logic Pro Page Save your EQ to a new preset file anywhere on your computer Digital Performer Page Page Waves Q-Clone Manual Known Issues Clone Loop Checklist Problem Synopsis Action Page Waves Q-Clone Manual
Top Page Image Contents