Waves Q-Clone manual Known Issues

c.Reset – Reset the preset by loading the reset preset file from the Load menu.

d.Add – By clicking the “Add” button you can load a new preset on top of an existing one. The “Add” mode gives the effect of having 2 or more EQ devices in a chain. There are 2 options for Add mode:

i.Open a Q-clone preset (from the Q-Clone preset menu or any directory on your hard drive) or use the existing displayed EQ curve. Click the “Add” button, and then make changes to it. Note that changes should be done from a flat EQ starting point.

ii.Load an EQ on top of the existing Q-Clone EQ curve on your screen. This preset can be loaded from the Q-Clone preset menu or from any directory on your hard drive.

17.You can use saved presets and factory presets in two ways: Load and Add. When you click the “Load” button (on the Waves menu bar) you can choose any preset from the preset list. Each preset will show you two options for loading. Load will allow you to upload the preset and use it instead of the one that you had before. Add will upload the preset on top of the one that you previously used.

KNOWN ISSUES:

1.We recommend working with the VST components in Cubase/Nuendo (and not with the DX). This is due “save session” problems with the DX components.

2.Clicking on the “Add” mode (in the Q-Clone) multiple times without changing the EQ settings may create a ripple and distortion in the Q-Clone graph.

3.Ripples may occur when capturing (This is due to an analog to digital path behavior).Make sure not to capture when they appear.

4.While Q-Clone or Q-Capture are open, sample rate changes in Cubase/Nuendo may cause unstable behavior in the EQ curves. To avoid this, close the plug-in instance first, then change the session sample rate and reopen the plug-in.

5.In Logic and in Sonar, playing or stopping the session may cause clicks in Q-Clone while it is in Capture mode. To avoid this, click the “Hold” button on Q-Clone before you start playback, and resume to “Capture” mode afterwards.

6.In all applications: The Flashing “No Transmission” while in Capture mode is a phenomenon related to high CPU load “hiccups”. When the CPU is at

Waves Q-Clone Manual 30