- | - Make sure | |
Transmission” on the | routed, is in bypass or | meters show “Transmitting” |
frequency response | disabled. | and “Receiving” messages. |
display. | - Signal is very low. | - Check your analog |
| ||
|
| connections. |
EQ Curve in the | Insufficient headroom | - Check clipping indicator in |
frequency response | in capturing either | the |
display does not seem | analog distortion or | headroom fader until digital |
smooth or is full of | digital clipping. | clipping stops (indicator |
ripples. |
| resets the meters by clicking |
|
| on them with the mouse). |
|
| - If distortion still occurs, |
|
| lower the fader some more to |
|
| prevent analog clipping. |
EQ Curve display | Sync problem | - Check if you are using too |
flickers or changes | is unable to lock to a | much headroom in Q- |
rapidly between | valid signal. | Capture. |
settings. |
| - Check if your device is |
|
| |
|
| valid for |
|
| definition on page 4. |
|
| - Try using a less extreme |
|
| EQ setting. |
|
| - Try closing the session and |
|
| reopen |
EQ Curve is empty. | Signal is too low. | Calibrate the |
|
| the |
|
| See directions in Page 11. |
Unstable behavior of the | EQ graphic curve look | Close the |
sluggish and unstable | first, then change the | |
Cubase/Nuendo after | in the | session’s sample rate and re- |
changing the session’s | frequency response | open the |
sample rate. | display |
|
Make sure | ||
audio. | silence | bypassed, muted or poorly |
|
| connected to the analog |
|
| hardware device through the |
|
| soundcard’s I/O. |
|
|
|
Waves | 33 |