D.Add – By clicking the “Add” button you can load a new preset on top of an existing one. The “Add” mode gives the effect of having 2 or more EQ devices in a chain. There are 2 options for Add mode:
i.Open a
ii.Load an EQ on top of the existing
16.You can use saved presets and factory presets in two ways: Load and Add. When you click the “Load” button (on the Waves menu bar) you can choose any preset from the preset list. Each preset will show you two options for loading. Load will allow you to upload the preset and use it instead of the one that you had before. Add will upload the preset on top of the one that you previously used.
Digital Performer 4.x:
1.Connect a cable from one of your audio card output ports into the input of the EQ device.
2.Connect a cable from the output of the EQ device to your audio card input port.
3.Set all of the frequencies gain knobs on your EQ device to 0 db.
4.Open your Audio Card control panel and make sure that this I/O setting is shown properly in the routing chart.
5.On the Digital Performer (DP) menu bar, go to:
A. “Studio” menu and check the “Audio Patch Thru” option.
Waves | 26 |