maximum capacity, the real time tasks have dropouts which result in flashing “No Transmission” messages.
7.Sonar will have a boost in the returned Capture signal. This can be fixed by applying digital corrective gain before the
Q-CLONE LOOP CHECKLIST:
1.Connect the EQ hardware device to the Sound card.
2.Connect an output port (mono only) from the audio card to the input port of the EQ device.
3.Connect the output port of the EQ device into the input port (mono only) of the audio card.
4.These steps can be done using the digital in/out ports as well (on your audio card) if the EQ device has digital I/O.
5.Open a session in one of the supported host applications and make sure that the audio card is listed as the active I/O of the application.
6.Make sure that your hardware EQ device is turned on and that it is in a flat setting (all faders and gain should be at 0 db). Any extra filters should be turned off.
7.Open the
8.Calibrate the
9.Open the
10.Press the Capture button in the
11.Once you get the desired preset, click the Hold button. This preset is now saved in the
12.You can add a preset “on top” of the existing one in one of two ways. The first is by clicking the Add button and ‘tweaking’ a new preset (starting from a flat EQ position again). The second option is to load an existing preset from your presets list and choose its Add version.
Waves | 31 |