
Chapter 2 QUICK SETUP Menu
•Disabled.The printer will not command the validator to begin scanning and no errors will be reported. The counters will not be incremented while the validator is disabled.
NOTE: If you save a configuration with the validator enabled, power down and power up, and the validator is not connected or not functioning, the error message “Validator not communicating” will display briefly. The Validator menu will not display.
If the validator is installed, the default is Enable.
Save Config.
Allows you to save up to eight unique configurations to meet different print job requirements. This eliminates the need to change the parameter settings for each new job. The configurations are stored in memory and will not be lost if you turn off the printer. The default is 1.
Power-Up Config.
You can specify one of the eight configurations as the
SMT: Status
This menu appears only if the RFID UHF encoder is installed. See “Software Migration Tools (SMT)” on page 63.
•Disabled.The printer will disable the use of the Software Migration Tools.
•Enabled. The printer will enable the use of the Software Migration Tools.
SMT: Sel Toolset
This menu appears only if the RFID UHF encoder is installed. See “Software Migration Tools (SMT)” on page 63.
•Toolset [1]. SMTs for PGL® emulation.
•Toolset [2]. SMTs for PPI1 emulation.
•Toolset [3] and Toolset [4]. Reserved for internal use and future design.
48