Chapter 3: Installation | 13 |
Chapter 3: Installation
This chapter describes how to install the ST60 Tridata instrument, and associated Speed and Depth transducers. The transducers are fitted in the hull of the vessel and connected to the rear of the instrument. The actual type of transducers depends on the type of hull in which they are to be installed.
For advice, or further information regarding the installation of this equipment, please contact the Raymarine Product Support Department or your own National Distributor.
3.1 Planning your installation
Before starting the installation, spend some time considering the best positions for both transducer and instrument, such that the Site Requirements and the EMC Guidelines (below) are satisfied.
Site requirements
Transducers
95 mm (3.75 in)
75 mm (2.94 in) diameter
| 75 mm (2.94 in) |
|
| diameter |
|
Depth | 100mm | (3.95in) |
Speed |
|
51 mm (2.0 in) | 5 mm | 51 mm (2.0 in) | 14 mm | |
(0.19 in) | diameter | (0.57 in) | ||
diameter | ||||
|
|
|
75 mm (2.94 in) | 75 mm (2.94 in) | |
diameter | ||
diameter | ||
|
The transducer types required for the various hull types are as follows: