Jus' Print RP-3200 User’s Manual
2-4. Dip Switch Setting
The printer is set up at the factory to be appropriate for almost all users. On the other hand, offers some more settings for users with special requirements.
It has DIP switches that allow you to change communication setting, such as handshaking and parity check, as well as print density.
Your printer has two sets of DIP switches. The functions of the switches are shown in the following tables.
♣Note : Power off. And open the cover of Dip Switch and change setting.
2-4-1. Serial Interface Specification
DIP Switch Set 1 Functions
SW | FUNCTION | ON | OFF | DEFAULT |
1 | Data Receive | Ignored | Print “?” | OFF |
2 | Hexadecimal | HEXDUMP | NORMAL | OFF |
3 | Hand Shaking | XON/XOFF | DTR/DSR | OFF |
4 | Data Length | 7bits | 8bits | OFF |
5 | Parity Check | ENABLED | DISABLED | OFF |
6 | Parity Check | EVEN | ODD | OFF |
Baud rate selection
Transmission speed | ||
4800 bps | ON | ON |
9600 bps | OFF | ON |
19200 bps | ON | OFF |
38400 bps | OFF | OFF |
Print Density (DIP-SW2)
Print Density | ||
Low Power | ON | ON |
Normal | OFF | ON |
Normal | ON | OFF |
Dark | OFF | OFF |
11