TVS electronic specifications Jus Print RP-3200 User’s Manual

Page 17

Jus' Print RP-3200 User’s Manual

♣CAUTION:

Turn off the printer while removing the DIP switch cover to prevent an electric short, which can damage the printer.

1.Make sure the printer is turned off.

2.Remove the screw from the DIP switch cover. Then, take off the DIP switch cover as shown in the illustration below.

3.Set the switches using a pointed tool, such as tweezers or a small screwdriver.

4.Replace the DIP switch cover. Then, secure it with the screw.

The new settings take effect when you turn on the printer.

16

Image 17

Contents Jus Print RP-3200 Page Table of Contents Parts Identiﬁcations Unpacking Setting Up the PrinterConnecting the Cables USB Interface Interface ConnectorSerial Interface Ethernet Interface Centronics Parallel InterfaceCash Drawer Connector Loading the Roll Paper Jus Print RP-3200 User’s Manual Serial Interface Speciﬁcation Dip Switch SettingBaud rate selection Print Density DIP-SW2Parallel Interface Speciﬁcation DIP Switch Set 1 FunctionCombo Serial Option USB Combo Interface SpeciﬁcationWi-ﬁ Interface Speciﬁcation USB Interface SpeciﬁcationCutter Ethernet Interface SpeciﬁcationEmulation Paper low detectJus Print RP-3200 User’s Manual Jus Print RP-3200 User’s Manual Control panel and other functions Error indicatorsControl panel Control PanelRunning the self test Self TestHexadecimal Dump To use the hex dump feature, follow these stepsHexadecimal Dump General Speciﬁcations SpeciﬁcationsOverall dimension Interface Electrical CharacteristicsAuto Cutter Speciﬁcations Certiﬁcation Environmental RequirementsReliability Remarks Command ListGS B Rev