Trango Broadband High Density Mesh System Getting Started, Opening the Box, Connections and Power

HD Mesh Node

Section 2 Getting Started

It is always a good idea to first provision and test the equipment on the bench before deploying them in the field. This is a particularly useful exercise for the novice user.

Opening the Box

Open the box by flipping up the quick release lockable latches.

Quick

Release

Lockable

Latch

Pull away from box

Flip Up

Connections and Power

Note: Improper wiring of power may power unit but may cause damage to system.

Figure 3

•Power is applied to the HD Mesh unit via the Power Input Terminals located at the bottom left hand corner inside the box.

•There are 5 PoE ports to provide connection to 5 Trango Broadband radios. Connect a Cat-5 (straight through) Ethernet cable (Trango Broadband recommends shielded twisted pair) between the POE port of the HD Mesh unit and the RJ-45 connector on the radio.

•Both green LEDs on the POE of the HD Mesh should be lighted, indicating power is present to the POE as well as the radio. (Figure 3)

Trango Broadband Wireless — High Density MESH page 7