Telenetics DSP9612RM manual Component View

Page 11

Hardware Overview

Component View

Figure 2-2 shows the component view of the modem. This view shows:

cTwo configuration switch blocks, designated SW1 and SW2. See page 12.

cJumpers located in various positions on the modem. Do not change or remove the straps from these jumpers.

cEdge connectors at the back of the modem, which plug into the backplane of a Telenetics or Motorola/UDS RM 16M Universal Data Shelf.

Configuration

Edge Connectors Switch Blocks

Switch Block SW2

Switch Block SW1

Figure 2-2. Component View of Modem

Page 11

Image 11

Contents DSP9612RM Flash Poll Rack-Mount Modem User’s Guide Compliances Contents Contents Chapter Introduction Features Ancillary Documentation ApplicationsIntroduction Additional Items You Need Chapter InstallationUnpacking Your Hardware Front View of Modem Hardware OverviewComponent View Configuring the Modem Installation SummaryConfiguring the Modem SW1-1 through SW1-4 − Transmit Level high- & low-speed modes SW1-5 − Receiver Dynamic Range high- & low-speed modes SW2-1 − Fast Poll/FSK high- & low-speed modes SW2-8 − Carrier Control high- & low-speed modes Low-Speed FSK Mode SW1-1 through SW1-4 Switch Settings SW1-6 and SW1-7 − RTS-CTS Delay low-speed mode only SW2-2 − CD Delay low-speed mode only SW2-5 − Soft Carrier low-speed mode only Installing the Modem in the Universal Data Shelf Installing the Modem in the Universal Data ShelfInstalling the Modem Modular Jack Connectors Connecting to a Transmission LineConnecting an RS-232 Device DLB LEDsIllustrates these three diagnostics Loopback Control SwitchProblem Solving Appendix a TroubleshootingPage General Specifications Appendix B SpecificationsMechanical Specifications RS-232 RTU Interface Back-to-Back Connections to a Second ModemCompliances Environmental SpecificationsAppendix C Limited Product Warranty Return Merchandise Authorization RMA Procedure Appendix D RMA Procedure