Telenetics DSP9612RM manual Configuring the Modem

Page 13

Configuring the Modem

Table 2-1. Modem Switch Settings for High-Speed Mode


Switches	Switch Settings
	ON	OFF (Default)
SW 1-1 − 1-4: Transmit Level (page 14)	(see Table 2-2 on page 14)

SW 1-5: Receiver Dynamic Range	−10 to −43 dBm	+3 to −30 dBm
(page 15)

SW 1-6: TX Cable Equalizer (page 15)	Enabled	Disabled

SW 1-7: RX Cable Equalizer (page 15)	Enabled	Disabled

SW 1-8: Anti-streaming (page 15)	Active	Inactive


SW 2-1: High-Speed/Low-Speed Mode	Low-Speed Mode	High-Speed Mode
(page 16)	(FSK)	(Fast Poll)

SW 2-2: Data Rate in Fast Poll Mode	4800 bps	9600 bps

SW 2-3: Async Character	11 bits	10 bits

SW 2-4: Auto RTS (page 16)	Enabled	Disabled

SW2-5: Reserved
SW 2-6: Production Test Only (page 16)	Test	Normal

SW 2-7: 2- or 4-wire (page 16)	2-wire, half-	4-wire, full-duplex
	duplex

SW 2-8: Carrier Control (page 17)	Constant	Switched

SW 2-9: Rx Termination (page17)	Disabled	Enabled

SW 2-10: Ground Options (page 17)	Chassis Ground-	Chassis Ground-
	Signal Ground	Signal Ground
	Connected	Disconnected

Page 13

Image 13

Contents DSP9612RM Flash Poll Rack-Mount Modem User’s Guide Compliances Contents Contents Chapter Introduction Features Ancillary Documentation ApplicationsIntroduction Unpacking Your Hardware Chapter InstallationAdditional Items You Need Front View of Modem Hardware OverviewComponent View Configuring the Modem Installation SummaryConfiguring the Modem SW1-1 through SW1-4 − Transmit Level high- & low-speed modes SW1-5 − Receiver Dynamic Range high- & low-speed modes SW2-1 − Fast Poll/FSK high- & low-speed modes SW2-8 − Carrier Control high- & low-speed modes Low-Speed FSK Mode SW1-1 through SW1-4 Switch Settings SW1-6 and SW1-7 − RTS-CTS Delay low-speed mode only SW2-2 − CD Delay low-speed mode only SW2-5 − Soft Carrier low-speed mode only Installing the Modem in the Universal Data Shelf Installing the Modem in the Universal Data ShelfInstalling the Modem Modular Jack Connectors Connecting to a Transmission LineConnecting an RS-232 Device DLB LEDsIllustrates these three diagnostics Loopback Control SwitchProblem Solving Appendix a TroubleshootingPage General Specifications Appendix B SpecificationsMechanical Specifications RS-232 RTU Interface Back-to-Back Connections to a Second ModemCompliances Environmental SpecificationsAppendix C Limited Product Warranty Return Merchandise Authorization RMA Procedure Appendix D RMA Procedure