Telenetics DSP 9612 manual Installation Summary, Finding a Suitable Location

Page 11

Installation

Installation Summary

The modem installation involves the following steps:

1.Finding a suitable location for the modem. See the section below.

2.Configuring the modem. See page 13.

3.Connecting to a transmission line. See page 25.

4.Connecting to a voltage source. See page 27.

5.Connecting a DTE device. See page 28.

Finding a Suitable Location

The location you select should provide easy access to the back panel communications interface(s) and front panel power interface. It should also let you view all the LEDs on the front panel.

Note: Telenetics also offers a rack-mount version of this modem (Model DSP9612RM) as a plug-in module for the Telenetics/UDS RM16M Central Site Modem Rack. For more information, contact Telenetics Corporation’s Sales Department at (949) 455-4000.

Page 12

Image 11

Contents DSP 9612 Flash Poll Modem User’s Guide Contents Contents Chapter Introduction Features Applications Network of Multipoint ConfigurationIntroduction Additional Items You Need Chapter InstallationUnpacking Your Hardware Hardware Overview InstallationFront View Finding a Suitable Location Installation SummaryConfiguring the Modem SW1 DIP Switch Settings SW1-1 through SW1-4 − Transmit Level SW1-5 − Receiver Dynamic Range SW2 DIP Switch Settings SW2-1  FSK Mode SW2-3  FSK Soft Carrier Bell 202 FSK Mode Only SW2-6  FSK CD Delay Bell 202 Mode Only SW3 DIP Switch Settings SW3-1 − Fast Poll Auto Rate/FSK SW3-2 − Data Rate Fast-Poll Mode Only SW3-5 − Transmitter Termination SW3-8 − Carrier Control Shows the transmission line interface Connecting to a Transmission LineTransmission Line Interface Connecting to a Voltage SourceConnecting an RS-232 Device DLB LEDsIllustrates these three diagnostics Loopback Control SwitchProblem Solving Appendix a TroubleshootingProblem Appendix B DIP Switch Summary DIP Switch Summary General Specifications Appendix C SpecificationsPower supply Mechanical SpecificationsInterface Connector Pin Assignments RS-232 DTE Interface Environmental SpecificationsCompliances Specifications Appendix D Compliances Department of Canada Statement Appendix E Limited Product Warranty Return Merchandise Authorization RMA Procedure Appendix F RMA ProcedureRMA Procedure