Telenetics DSP 9612 manual Problem

Page 31

Troubleshooting

Table A-1. Troubleshooting Suggestions

If…	Perform These Procedures…

	problem.

The RTS, CTS, and TxD	The attached terminal or DTE may not
LEDs do not blink.	be sending data to the modem. Verify
	that data is being transmitted. If data is
	being transmitted, make sure the RS-
	232 cable is sound and securely
	connected to the modem and terminal
	or DTE.

Page 32

Image 31

Contents DSP 9612 Flash Poll Modem User’s Guide Contents Contents Chapter Introduction Features Applications Network of Multipoint ConfigurationIntroduction Unpacking Your Hardware Chapter InstallationAdditional Items You Need Hardware Overview InstallationFront View Finding a Suitable Location Installation SummaryConfiguring the Modem SW1 DIP Switch Settings SW1-1 through SW1-4 − Transmit Level SW1-5 − Receiver Dynamic Range SW2 DIP Switch Settings SW2-1  FSK Mode SW2-3  FSK Soft Carrier Bell 202 FSK Mode Only SW2-6  FSK CD Delay Bell 202 Mode Only SW3 DIP Switch Settings SW3-1 − Fast Poll Auto Rate/FSK SW3-2 − Data Rate Fast-Poll Mode Only SW3-5 − Transmitter Termination SW3-8 − Carrier Control Shows the transmission line interface Connecting to a Transmission LineTransmission Line Interface Connecting to a Voltage SourceConnecting an RS-232 Device DLB LEDsIllustrates these three diagnostics Loopback Control SwitchProblem Solving Appendix a TroubleshootingProblem Appendix B DIP Switch Summary DIP Switch Summary General Specifications Appendix C SpecificationsPower supply Mechanical SpecificationsInterface Connector Pin Assignments RS-232 DTE Interface Environmental SpecificationsCompliances Specifications Appendix D Compliances Department of Canada Statement Appendix E Limited Product Warranty Return Merchandise Authorization RMA Procedure Appendix F RMA ProcedureRMA Procedure