Telenetics DSP 9612 manual SW2 DIP Switch Settings

Page 16

Configuring the Modem

SW2 DIP Switch Settings

SW2 is an 8-position DIP switch. Table 2-3 shows the modem switch settings for DIP switch SW2. A description of the SW2 switch settings follows the table.

Table 2-3. Modem Switch Settings for DIP Switch SW2


Switches		Switch Settings
	ON		OFF (Default)
SW2-1: FSK Mode (page 18)	V.23		Bell 202

SW2-2: Receiver Squelch (page 18)	Turnaround		Turnaround
(valid for FSK mode, 2-wire half-duplex	Squelch (Bell		Squelch (Bell 202):
operation only)	202): 8ms		0ms
	Turnaround		Turnaround
	Squelch (V.23):		Squelch (V.23):
	150ms		0ms
SW2-3: FSK Soft Carrier (page 19)	Disabled		Enabled

SW2-4 and SW2-5: FSK RTS-CTS		(see Table 2-4)
Delay (page 19)
SW2-6: FSK CD Delay (page 20)	23ms		6ms

SW2-7: Remote Loopback (page 20)	Enabled		Disabled
SW2-8: Reserved (Test Only) (page 20)	Test		Normal

Page 17

Image 16

Contents DSP 9612 Flash Poll Modem User’s Guide Contents Contents Chapter Introduction Features Network of Multipoint Configuration ApplicationsIntroduction Unpacking Your Hardware Chapter InstallationAdditional Items You Need Installation Hardware OverviewFront View Installation Summary Finding a Suitable LocationConfiguring the Modem SW1 DIP Switch Settings SW1-1 through SW1-4 − Transmit Level SW1-5 − Receiver Dynamic Range SW2 DIP Switch Settings SW2-1  FSK Mode SW2-3  FSK Soft Carrier Bell 202 FSK Mode Only SW2-6  FSK CD Delay Bell 202 Mode Only SW3 DIP Switch Settings SW3-1 − Fast Poll Auto Rate/FSK SW3-2 − Data Rate Fast-Poll Mode Only SW3-5 − Transmitter Termination SW3-8 − Carrier Control Connecting to a Transmission Line Shows the transmission line interfaceConnecting to a Voltage Source Transmission Line InterfaceConnecting an RS-232 Device LEDs DLBLoopback Control Switch Illustrates these three diagnosticsAppendix a Troubleshooting Problem SolvingProblem Appendix B DIP Switch Summary DIP Switch Summary Appendix C Specifications General SpecificationsMechanical Specifications Power supplyInterface Connector Pin Assignments Environmental Specifications RS-232 DTE InterfaceCompliances Specifications Appendix D Compliances Department of Canada Statement Appendix E Limited Product Warranty Appendix F RMA Procedure Return Merchandise Authorization RMA ProcedureRMA Procedure