22
MECHANICAL INSTALLATION 110CS
5)Install the 4 supplied 3/4” wood screws being careful not to strip the holes in the subwoofer.
Two additional anchor screws should be installed up near the top rear edge of the subwoofer in the cavity where the control panel is located. The position of these two screws should correspond to the vertical pencil lines drawn earlier.
6)Drill a hole in the cabinet at each pencil line, 1” from the top edge of the cabinet and install an appropriate lag screw* through each and into the wall studs.
PLEASE NOTE that there will be a space between the wall and the cabinet.
These two screws should be firm, but do not attempt to over tighten or close the cabinet/wall gap by force of the screw. The screws are for preventing the subwoofer from falling forward and do not support the weight of the unit. (Fig. 3)
7)Once the unit is level and secure, reinstall the bottom panel and its spacers with the Allen head bolts removed earlier. Peel off and remove the bottom rubber feet if desired.
8)Replace the
* NOTE: As wall thickness and materials vary, we do not provide lag screws for the wall mounting of the rails.
Figure 3
Figure 4