Tally Genicom T2250, T2150 manual Installation Quick Start-up

Page 8

Installation

Quick Start-up

➤Placing your printer Place the printer on a solid, flat and non-slip surface in such a way that it cannot fall down. Make sure to facilitate access to the control panel and the paper input trays and to leave sufficient space for the paper ejected.

If you expect that frequent forward and reverse feeds will occur, you should place the printer as shown in the figure, if possible.

STOP

When selecting the printer location, observe the following additional instructions:

Never place the printer in the vicinity of easily inflammable gas or explosive substances.

Do not expose the printer to direct sunlight. If you cannot avoid placing the printer near a win- dow, protect it from the sunlight with a curtain.

When connecting the computer with the printer, make sure not to exceed the permitted cable length (see Reference Manual on the online CD-ROM, Technical specifications).

Ensure sufficient distance between the printer and any heating radiators.

Avoid exposing the printer to extreme temperature or air humidity fluctuations. Protect the printer from dust.

It is recommended to install the printer in a place which is acoustically isolated from the workplace because of the noise it may produce.

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents T2150 T2250 Important Information Table of contents Quick START-UPIntroduction Symbols usedImportant safety instructions Using ContentsRequirements Troubleshooting Online-CD-ROMPrinter in fanfold paper mode Printer in single sheet mode Printer at a glanceInstallation Unpacking the printerInstallation Quick Start-up Lisgne Checking the printer voltageConnecting the printer Switching on the printerOnline mode Control panelOnline Tractor1 Tear Offline Tractor1 Park LoadAdjust Paperway Menu Char Setup modeChanging Ribbon cassetteQuick Start-up Paper handling ASF-R Next Load paper from SingleOnline Single Load Paper path quickYou can use, please refer to page 24 Paper specifications Loading paperBe problems in the feeding process Single sheets Offline Tractor1 Park LF/FF Paper transportMoving the paper to the tear position Tear position Tractor1Online Tear Settings Setting the tearHead Tear TearAdj= 00/72* Set ExitPrinting line TOF Setting the firstFormAdj= 12/72* Set Exit Head= Set Exit GapSelecting character density and font Adjust Paperway Menu Char Font CPI10 CPI Set Exit Roman NLQ Set Exit Englis Accessories Paper specificationsTrademark Acknowledgements Tally Representatives Germany France Russian Federation and C.I.S
Top Page Image Contents