Motherboard Description |
|
1-6.5 Multiplexed AGP and Display Cache Interface
The Intel® 815E GMCH multiplexes an AGP interface with a display cache interface for internal 3D graphics performance improvement. The Display Cache is used only in the internal graphics. When an AGP card is installed in the system, the Intel® 815E GMCH internal graphics will be disabled and the AGP controller will be enabled.
1-6.5.1 AGP Interface
A single AGP connector is supported by the Intel® 815E GMCH AGP interface. The AGP buffers operate in one of two selectable modes in order to support the AGP Universal Connector:
1)3.3V drive, not 5 volt safe – This mode is compliant to the AGP 1.0 and 2.0 specs.
2)1.5V drive, not 3.3 volt safe – This mode is compliant with the AGP 2.0 spec.
The following table shows the AGP Data Rate and the Signaling Levels supported by the GMCH:
| Signaling Level | |
Data Rate | 1.5V | 3.3V |
1x AGP | Yes | Yes |
2x AGP | Yes | Yes |
4x AGP | Yes | No |
The AGP interface supports 4x AGP signaling. AGP semantic (PIPE# or SBA[7:0]) cycles to SDRAM are not snooped on the host bus. AGP FRAME# cycles to SDRAM are snooped on the host bus. The GMCH supports PIPE# or SBA[7:0] AGP address mechanisms, but not both simultaneously. Either the PIPE# or the SBA[7:0] mechanism must be selected during system initialization. High priority accesses are supported. Only memory writes from the hub interface to AGP are allowed. No transactions from AGP to the hub interface are allowed.
10