SOYO mother board fc-pga socket 370 pocessor supported, sy-7isa+ manual Power On

Hardware Installation SY-7ISA+

2-3.7 Power On

You have now completed the hardware installation of your Motherboard successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot up sequence is completed. Then push the RESET button and press <DEL> key again at the beginning of boot-up, during diagnostic checks.

Repeat this operation until you get the following screen.

3. The BIOS Setup screen appears:

CMOS Setup Utility – Copyright ( C ) 1984-2000 Award Software

SOYO COMBO Feature	PC Health Status
Standard CMOS Features	Load Fail - Safe Defaults
Advanced BIOS Features	Load Optimized Defaults
Advanced Chipset Features	Set Supervisor Password
Integrated Peripherals	Set User Password
Power Management Setup	Save & Exit Setup
PnP/PCI Configurations	Exit Without Saving
Esc : Quit	: Select Item
F10 : Save & Exit Setup

Change CPU’s Clock & Voltage

45