SOYO SY-6IEB quick start Quick Bios Setup, Select Load Setup Default, Select Standard Cmos Setup

Page 10

Quick BIOS Setup

SY-6IEBQuick Start Guide

3 Quick BIOS Setup

This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead, CPU settings are software configurable with the BIOS [SOYO COMBO SETUP]. The [SOYO COMBO SETUP] menu combines the main CPU parameters that you need to configure, all in one menu, for a quick setup in BIOS.

After the hardware installation is complete, turn the power switch on, then press the <DEL> key during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.

Step 1. Select [LOAD SETUP DEFAULT]

Select the “LOAD SETUP DEFAULT”menu and type “Y”at the prompt to load the BIOS optimal setup.

Step 2. Select [STANDARD CMOS SETUP]

Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.

Step 3. Select [SOYO COMBO SETUP]

Move the cursor to the [CPU Speed] field to set the CPU working speed.

Available [CPU Speed] settings on your SY-6IEB Motherboard are detailed in the following table. If you set this field to [Manual], you are then required to fill in the next two consecutive fields: (1) the CPU Ratio, and (2) the CPU Frequency.

CPU Speed

 

233MHz (66x3.5)

 

366MHz (66x5.5)

 

 

 

 

 

 

 

266MHz (66x4.0)

 

400MHz (66x6.0)

 

 

 

 

 

 

 

300MHz (66x4.5)

 

433MHz (66x6.5)

 

 

 

 

 

333MHz (66x5.0)

 

 

 

 

 

 

Select the working frequency of your Pentium® II, or Celeronprocessor among these preset values.

Note: Mark the checkbox that corresponds to the working frequency of your Pentium® II, or Celeronprocessor in case the CMOS configuration should be lost.

Step 4. Select [SAVE & EXIT SETUP]

Press <Enter> to save the new configuration to the CMOS memory, and continue the boot sequence.

10

Image 10
Contents Quick Start Guide SY-6IEB Motherboard 6IEB Serial Version 2.0 Edition MarchIntroduction UnpackingSY-6IEB Motherboard Layout Installation PreparationsInstall the CPU Retention ModuleMake Connections to the Motherboard Enable/Disable the Keyboard Wake-Up JP10 Configure MemorySet the CPU Frequency Clear Cmos Data JP5 Retain Cmos Data Clear Cmos DataSelect Standard Cmos Setup Quick Bios SetupSelect Load Setup Default Select Soyo Combo SetupInsert the Soyo CD into the CD-ROM drive Soyo CDRead Soyo 6IEB Manual Install Drivers Driver Installation Menu Intel Southbridge Drivers Enter the Soyo CD USA Branch Office Edition March VersionInternational Headquarters Soyo Europe