Muratec MFX-1300/1700 manual Errors, Error reports, Kinds of error codes, Specific errors

What you see on the LCD	What it means/What to do
Too Many Steps	You tried to enter too many steps for a macro. You
	can enter up to 60 steps into a macro key.
Unable to Reduce	In the reduction copy using the ADF,ifthe
	calculated ratio is smaller than minimum reduction
	ratio (50%), this message will appear and you can-
	not make the reduction copy.
	Use the FBS glass, however parts of the image
	might not be copied.
Use FBS Glass	You tried to enlargement copy using the ADF.
	Your machine cannot enlargement copy from the
	ADF. Please set your document on the FBS glass to
	make the enlargement copy.

Just in case

Errors

When sending faxes, your machine occasionally runs into communications errors. These can be caused by anything from lightning to telephone line interference. (These same factors cause the static,or line noise, you sometimes hear on phone calls.) They also can be caused by problems with the fax machine at the other end of the line.

Often, simply trying your call again is all that s necessary. However,if the problem per- sists regularly,call your local telephone company for help. If that doesn t help and the problem persists regularly, call your authorized Muratec dealer.

Error reports

When an error occurs, your fax machine prints an error report. Each fax error report lists an error message which includes:

A possible solution to the problem

The sending location (if the remote fax stores a Location ID ofits own)

The result which is a special error code.

A sample of the document sfirstpage.

Kinds of error codes

The error code listed in the Result column of the error report indicates the specific problem encountered:

D	codes	Occur while dialing
R	codes	Occur during reception
T	codes	Occur during transmission

Specific errors

Following are some error codes you may see on an error report:

Dialing errors

D.0.3,	The remote unit didn t respond, the call couldn t be completed or STO P was
D.0.8	pressed during dialing. Re-try the call. If your machine repeats the message,
	call the remote fax unit s operator and verify that unit is operating properly.
D.0.2	The remote unit is busy.Try the call again.
D.0.6,	Either the remote unit didn t respond, the call somehow didn t go through or
D.0.7	STO P was pressed during dialing. Try the call again.

5.9