Muratec MFX-1300/1700 manual Turning off the transport mode, Adjust the monitor speaker s volume

Getting started

Turning off the transport mode

Important:	After unlocking the mirror carriage (see page 1.5), you must turn the
	transport mode off by following procedures.

When the machine is in the transport mode, the LCD shows:

Mirror Locked

To turn off the transport mode:

1 Press Program key,*, E.

		Mirror Locked	:On
		/	/Enter
2
	Select Off by pressing		or .Then press ENTER to turn off the transport mode.
	The mirror carriage will move to the home position.

Mirror Locked :Off / /Enter

Important: If you must reship the machine, turn on this mode to move the mirror car- riage to the transport position (in step 2, above, press or to set the transport mode to On), then power off and lock the mirror carriage using the mirror carriage locking plate (see page 1.5).

Adjust the monitor speaker s volume

You can set the volume of the monitor speaker.

1	Press MONITO R/CALL on the control panel. You now should hear a dial tone.
	And press		or of the cursor key.The LCD indicates the volume:
		**	Tel Mode **
		Volume:■■ ■■ ■■
2
	To turn the volume up, press .
	To turn the volume down, press .
3	Press MONITO R/CALL again to hang up.

Loading paper

Acceptable paper size and cassette capacity

Paper source

Paper type

Paper size

Capacity

Paper cassette

Plain paper*1

Letter

, Legal

,Half-letter

500 sheets

Letter

, Legal

,Half-letter

,

Plain paper*1

A4

,A5

,A6

, F4

,

50 sheets

Bypass Tray

Executive

, Custom-sized*2

Envelopes

DL

, CM10

, Monarch

1 sheet

Postcard

3.9″ ⋅ 5.8″ (100 ⋅ 148mm)

20 sheets

Transparency*3

Letter

20 sheets

*1

Paper weight: 60

90 g/m2

*2

(3.8 8.5) inches

(5.5 14.0) inches (Width

Length): It only can use if the optional

Printer Controller is attached.

*3

W e recommend: 3M PP2500 for laser printers or equivalent

Note: Do not use any paper which has been creased, wrinkled or has absorbed any moisture.

Loading paper in paper cassette

Before you load paper, note the following:

After you loaded paper in paper cassette, you must need to tell your machine which size of the paper, letter-, legal- or half letter-sized, you loaded.

You can do this by the Setting of the paper size operation. (See next page.)

Note: If you will be using letter-sized paper,there s no need to adjust the cassette; your machine is initially set for Letter-sized paper. Simply attach the LTR sticker to the outside of the paper cassette.

1 Openyou. the paper cassette from the front of your machine by gently pulling it toward

1.8