SOYO SY-6IEB quick start Install the CPU, Retention Module

Hardware Installation

SY-6IEBQuick Start Guide

Install the Motherboard

Follow the steps below in order to perform the installation of your new SY-6IEBMotherboard.

Step 1. Install the CPU

Mark your CPU Frequency: Record the working frequency of your CPU that should be clearly marked on the CPU cover.

FSB 66MHz

266MHz (66 x 4.0)	333MHz (66 x 5.0)	400MHz (66 x 6.0)
300MHz (66 x 4.5)	366MHz (66 x 5.5)	433MHz (66 x 6.5)

CPU Mount Procedure: To mount the processor that you have purchased separately, follow these instructions.

Retention Module Step 1. Open the two sides by folding them up.

Step 2. Push the locks on top of the CPU Step 3.	Insert the CPU into the retention
inward.	module. The CPU fits in the CPU slot in
	only ONE way, do not try to force it in.

Step 4. After completely inserting the CPU, push the two locks on

top of the CPU outward. Now your CPU is ready for use.

To remove the CPU, press the two notches on top of the CPU inward. Now press the two slides on the retention module down and remove the CPU.

Note: Installing a heat sink and cooling fan on top of your CPU is necessary for proper heat dissipation. Failing to install these items may result in overheating and possible burn-out of your CPU.

6