Cabletron Systems manual Unpacking the HSIM-W6, Guidelines for Installations

5 Installation

This chapter outlines the procedure for attaching the HSIM-W6 to the network. To install the HSIM and WPIMs, you need the following items:

•Antistatic wrist strap (provided with the HSIM-W6)

•Phillips screwdriver

Unpacking the HSIM-W6

Unpack the HSIM-W6 as follows:

1.Remove the shipping material covering the HSIM-W6 in the shipping box.

2.Carefully remove the HSIM-W6 from the shipping box. Leave the module in its non-conductive bag until you are ready to install it.

3.Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package).

4.After removing the module from its non-conductive bag, visually inspect the device. If there are any signs of damage, contact Cabletron Systems (refer to Chapter 1, Getting Help) immediately.

Guidelines for Installations

Only qualified personnel should perform installation procedures.

Installation sites must be within reach of the network cabling and meet the requirements listed below:

•A properly grounded power receptacle must be within seven feet of the location.

•In a shelf installation, the shelf must be able to support 13.6 kg (30 lb) of static weight for each device on the shelf.

HSIM-W6 User’s Guide 49