Cabletron Systems HSIM-W6 manual Installing an Hsim in an Interface Module

Chapter 5: Installation

Installing an HSIM

You can install an HSIM-W6 in any Cabletron Systems device that supports HSIM technology (e.g., SmartSWITCH 2200, SmartSWITCH 6000). Refer to the release notes for the version of firmware running on the Cabletron Systems device to ensure that the HSIM-W6 is supported. The following sections provide generic instructions for installing an HSIM-W6 in a SmartSWITCH interface module or in a SmartSWITCH chassis. Refer to your specific interface module or chassis documentation for exact HSIM slot and connector locations.

Installing an HSIM in an Interface Module

To install an HSIM in a module that supports HSIM technology refer to Figure 14 and Figure 15 and complete the following steps:

1.Disconnect all network cables from the interface module. Note the ports to which these cables are attached.

2.Attach the disposable antistatic wrist strap.

3.Unlock the top and bottom plastic locking tabs of the module faceplate.

4.Slide out the interface module and place it on its side with the internal components facing up.

5.Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure 14.

6.Remove and save the two standoff screws.

54 HSIM-W6 User’s Guide