Cabletron Systems HSIM-W6 manual Reconnect the chassis to your network

Chapter 5: Installation

2.Disconnect all network cables from the chassis. Note the ports to which these cables attach.

Ensure that you remove the power cord and ONLY the screws required to remove the chassis cover. Failure to comply could result in an electric shock hazard.

3.Attach the antistatic wrist strap.

4.Remove the chassis cover (refer to your specific chassis documentation for instructions on removing the chassis cover).

5.Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure 14.

6.Remove and save the two standoff screws. See Figure 14.

7.Place the HSIM behind the chassis faceplate. See Figure 15.

8.Ensure that the standoffs on the chassis align with the standoff screw holes on the HSIM to prevent bending the pins and insert the connector pins of the HSIM into the HSIM connector on the chassis motherboard.

9.Press down firmly on the back of the HSIM until the pins slide all the way into the connector holes.

10.Secure the HSIM to the faceplate using the screws saved in step 5.

11.Secure the HSIM to the standoffs using the screws saved in step 6.

Ensure that the chassis cover is in place before reconnecting the power cord.

12.Reattach the chassis cover to the chassis and reconnect the power cord.

NOTE

Proceed with step 13 ONLY after the HSIM-W6 is configured withQuickSET (refer to

Chapter 6).

13.Reconnect the chassis to your network.

HSIM-W6 User’s Guide 57