Cabletron Systems HSIM-W6 manual WAN Setup, WAN Physical Configuration Screen

Chapter 7: General Configuration Using Local Management

WAN Setup

NOTE

This section describes the HDSL WPIM. For all other WPIMs, refer to your specific WPIM(s) Local Management Guide for information on this screen.

The WAN Setup menu item accesses two screens which allow you to configure the HSIM-W6 for a WAN Physical Interface Module (WPIM).

Access the WAN Physical Configuration screen, shown in Figure 68, by using the arrow keys to highlight the WAN SETUP menu item and pressing ENTER. The WAN Physical Configuration screen displays.

Local Management			Flash Image Version XX.XX.XX
		WAN PHYSICAL CONFIGURATION
WPIM 1		WPIM 2
Type:	HDSL	Type: T1
BRIM #: 1		BRIM #: 2
Mode:	[Primary]	Mode: [Primary]
Active: Yes		Active: Yes
Ifaces: 003-026		Ifaces: 027
WPIM 1 Line Configuration
HDSL Tx Clock Source:		[Loop-Timing]
HDSL Timeslot Configuration:		[Fractional]
SAVE	[WPIM 1]	WAN INT CONFIG	RETURN

Figure 68 WAN Physical Configuration Screen

164 HSIM-W6 User’s Guide