Cabletron Systems HSIM-W6 manual Csx-Comp/Encr

Chapter 5: Installation

3.Install the CSX-COMP/ENCR in the HSIM-W6 by unlocking the top and bottom plastic locking tabs of the module faceplate. Slide out the module and place it on its side with the internal components facing up.

NOTE

Ensure that the CSX-COMP/ENCR is aligned such that its connector pins correctly align with the D-Type connector on the HSIM-W6.

4.Locate the D-Type connector and the standoffs on the HSIM-W6 (refer to Figure 13).

5.The D-Type connector pins of the CSX-COMP/ENCR only fits one way onto the HSIM-W6 D-Type connector. Lower the CSX-COMP/ENCR onto the standoffs and align the connector with the connector pins. Carefully insert the connector pins of the CSX-COMP/ENCR into the connector on the HSIM-W6.

6.Press down firmly on the CSX-COMP/ENCR until the pins fit all the way into the connector.

7.Secure the CSX-COMP/ENCR with the standoff screws supplied with the CSX-COMP/ENCR. The CSX-COMP/ENCR installation is complete.

Standoff Screws

D-Type

Connector Pins

D-Type

Connector

CSX-COMP/ENCR

Standoff

Detail

2204N01

Figure 13 CSX-COMP/ENCR

HSIM-W6 User’s Guide 53