Status STS LED is Amber blinking | Cabletron Systems HSIM-W6

WPIM-DDS Installed in HSIM-W6

The DDS circuit is Out of Service (OOS).

•Contact your WAN DDS Service Provider and have them test the operation of your DDS circuit.

Status (STS) LED is AMBER (blinking)

•Device is in test mode.

•The CSX400 is running its Power-up Diagnostic Tests.

•Loopback Testing is underway on a WAN circuit.

WPIM-SYNC Installed in HSIM-W6

The Port is operating normally; Request to Send (RTS) has been activated by your WAN device. If it is not, use the following steps:

•Use QuickSET or Local Management to make sure that the WAN interface on the local device is conﬁgured properly.

•Verify the cabling being used between the HSIM-W6 and the CSU/DSU.

WPIM-HDSL is Installed in HSIM-W6

The Port is operating normally, the WPIM is synchronized with the HDSL circuit at the remote end.

WPIM-S/T is Installed in HSIM-W6

The Port is operating normally, ISDN BRI channel B1 or B2 or both are active.

206	HSIM-W6 User’s Guide