Cabletron Systems manual HSIM-W6 User’s Guide

Chapter 7: General Configuration Using Local Management

To enable RIP , complete the following steps:

1.From the IP Configuration screen, highlight IP RIP and then press ENTER. The IP RIP CONFIGURATION screen, shown in Figure 62, displays.

2.Use the arrow keys to highlight the System Level RIP-1field.

3.Use the ENTER key to toggle the entry to ENABLED.

4.Use the arrow keys to highlight the Port Level RIP-1field.

5.Use the ENTER key to toggle the entry to ENABLED.

6.Use the arrow keys to highlight the SAVE command at the bottom of the screen, and then press ENTER. The message “SAVED OK” displays.

HSIM-W6 Local Management Flash Image Version XX.XX.XX

IP RIP CONFIGURATION

IP Address: xxx.xxx.xxx.xxx

Port: 1

System Level RIP-1:	DISABLED
Port Level RIP-1:	DISABLED

+PORT- SAVE RETURN

Figure 62 IP RIP Configuration Screen

152 HSIM-W6 User’s Guide