nsta Uation Instructions (continue€
9÷p 8
BnstaHing the Anti-Tip Device
WARNING:
o Range must be secured with an approved Anti- Tip device,
o Unless properly installed, the range could be tipped by an adult or a child standing, sitting or leaning on an open door or drawer
o After installing the
o This range has been designed to meet all recog- nized industry tip standards for all normal conditions
o The use of this device does not preclude tipping of the range when not properly installed
•If the
1.Mark the wall where the RIGHT EDGE of the range is to be located Be sure to allow for the countertop
overhang if you intend to install the range next to cab- inets.,
|
|
| |
|
|
|
|
I]Device | ] | ||
Slotled | _ | t | |
Head _3_,,_, | UIj, | 1I | |
crow l 1-Tl!Wo,,p,a,o]
Appro× 20 _dZL[J_ |
| I | |
7 | ,31/_. | .. | Marked Edge |
/" | (_ 78 | of Range | |
2.Locate the outside edge of the device 2¼" toward the center of the range from the marked edge of the range,
3.Using the device as a template, mark the position of the hole for the screw
Back of
WallboardRange
Device
Wood Screw
4.For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal A nail or awl may be used if a drill is not available
Mount the
For cement or concrete construction, you wil! need a 1/4" x 1W'lag bolt and a 1/2" O.D. sleeve anchor,
which are not provided Drill the recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.
5.Slide the range against the wall, and check for proper installation by grasping the front edges of the rear surface unit openings and carefully attempting to tilt the range forward°
WHEN ALL HOOKUPS ARE COMPLETED
MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION AND VENTILATION AIR TO THE RANGE IS UNOB- STRUCTED.
10
