Kenmore 73819, 73511, 73515, 73811 manual Timer, Display, Clocl<

Clocl<

The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a TIME BAKE or CLEAN cycle

To Set the Clock:

Step 1. Touch the CLOCK pad The word "TIME" will flash in the display

The timer, as you are setting it, will display seconds until 60 seconds is reached, Then it will display min- utes and seconds until 60 minutes is reached, After 60 minutes, it will display hours ("HR" now appears in display) and minutes until the maximum time of 9 hours and 55 minutes is reached

To Reset Timer:

Touch TIMER pad and then press & hold or tap INCREASE or DECREASE pad until desired time is reached

Step 2. Press & hold or tap INCREASE or DECREASE pad to set the time of day, (Tap to change time 1 minute a tap. Press & hold to change time 10 minutes at a time )

Example: Try setting the time for 3:00 Use a combi- nation of presses and taps to get familiar with the con- trol Since this is a 12-hour clock, there is no need to worry about AM or PM

If you accidentally go past 3:00, sh-nply press & hold or tap the DECREASE pad untl the time shows in the display

bq Case of Power Outage:

After a power outage, when power is restored the dis- pIay wilt flash and time shown will no longer be cor- rect

Display flashes until clock is reset., Al! other functions that were in operation when the power went out will have to be programmed again

Timer

The timer does not control oven operations, The max- imum setting on the timer is 9 hours and 55 minutes

To Set The 'Timer:

Step 1. Touch the TIMER pad The word "TIMER" will flash in tile display.

Step 2. Press & hold or tap INCREASE or DE- CREASE pad to set the amount of time on timer (Pressing & holding the pad changes time in Iarge amounts Short taps change time in smater amounts)

The timer will start automatically within a few seconds of releasing the INCREASE or DECREASE pad

To Cancel Timer:

Press & hold TIMER pad until the word "TIMER" quits flashing on the display (about 4 seconds)

"['ones

The end-of-cycle tone will sound at the end of time oven functions The end-of-cycfe tone is a steady sig- nal that repeats every 6 seconds until you touch any operation If you would like to change the tone to a set of 3 short beeps, press & hold CLEAR/OFF for 10 seconds

To return the end-of-cycle tone to a steady repeating signal, press & hold CLEAR/OFF for 10 seconds

Display

Programmed information can be displayed at any time by touching the pad of the operation you want to see For example, you can display the current time of clay while the timer is counting down by touching the CLOCK pad

"door" appears on display, The oven door is in the locked position. BAKE, BROIL and COOK TIME can- not be set if the door is in the locked position.,

"F-" and a number flash on display. This is the function error code. If function error code appears

during the self-cleaning function, check oven door latch--the latch handle may have been moved, even if only slightly, from the latched position Make sure handle is to the right as far as it will go, Touch

CLEAR/OFF pad if function error code does not

dear, disconnect power to the range and call for ser- vice

19